Cloud-electronics VTX-WM1 Manual do Utilizador descarregar pdf (Página 6)

VTX-WM1 Installation Guide v1.26







































 

 











  





 

 







8. The VTX-WM1 card can now be tted

in place; the two rear supports should

engage with the edge of the heatsinks,

and the RJ-45 Ethernet connector should

protrude through the rear panel slot.

The two previously empty holes in the

amplier rear panel should align with the

tapped holes in the card’s rear brackets;

secure the card using the two screws

supplied.

9. Locate the spare internal AC cable coming

from the amplier power transformer. This

will have one red and two yellow wires

and will terminate in a 3-pin Molex plug.

It may be cable-tied; if so, cut the tie. Plug

the connector into the large 3-pin Molex

header on the front left corner of the

VTX-WM1 card.

10. Fix the new rear plate (supplied) over the

card slot using the two screws removed

in Step 3, so that the RJ-45 connector is

engaged with the square hole in the plate.

Replace the top cover.

11. We recommend that the amplier is

connected to a computer at this stage

to check communications. Connect the

VTX-WM1 card’s Ethernet port to the

network port on a computer using a

standard CAT5 (or CAT5-e) network

cable, terminated with RJ45 plugs. Either

a “straight” or a “crossed” cable may be

used, as the VTX-WM1 auto-detects the

data lines. Power the amplier on; it is

not necessary at this stage to connect

any audio inputs or outputs. Turn the

computer on and check that it has a static

IP address of the form 192.168.0.xxx,

where xxx can be any value between

1 and 254 except 127. Launch the Internet

browser normally used (e.g., Microsoft

Internet Explorer, Mozilla Firefox, Safari,

etc.)

12. Type the card’s default IP address -

192.168.0.127 - into the URL eld of the

browser, and the screen shown below

should appear:

The amplier type listed in the title

should be that of the amplier in use. This

conrms that the data communications

section of the card is operating correctly.

The card’s IP address can be changed

subsequently, and this procedure is

discussed in “Entering site and amplier

information” on page 8.

13. Close the browser application. The

amplier may now be disconnected from

the computer and powered off. Reinstall in

the rack and reconnect all rear cables.

14. Repeat the above procedure for the

remaining VTX ampliers.

POWER

CONNECTOR

1 2 3 4 5 6 7 8 9 10 11 ... 20 21

Comentários a estes Manuais

Sem comentários