Cloud-electronics LM-1 Manual do Utilizador descarregar pdf (Página 5)

4 LM-1: Installation & User Guide

If the Z4 or Z8 is in default configuration all mic signals will override LM-1 signals, to remove

this priority set internal jumper ‘J4’ to the ‘OFF’ position.

Location of Jumper J4

When setting the jumper(s) please ensure that you:

• Remove the mains cable from the rear of the product before removing the top panel.

• Only reassemble the unit using bolts/screws identical to the original parts.

5d Configuring a 46/50

to an LM-1

When an LM-1 is connected to a 46/50 please ensure that the music control switch is

depressed. If the LM-1 fails to change the music sources, check the jumper J3, which

should be in the ‘SW’ position.

Jumper locations on the 46/50 PCB

If the 46/50 is in default configuration all mic signals will override LM-1 signals, to remove

this priority set internal jumper ‘J11’ to the ‘OFF’ position.

Location of Jumper J11

When setting the jumper(s) please ensure that you:

• Remove the mains cable from the rear of the product before removing the top panel.

• Only reassemble the unit using bolts/screws identical to the original parts.

04-11-02 V4.0

1 2 3 4 5 6 7 8

Sem comentários

Cloud-electronics LM-1 Manual do Utilizador Página 5