Cloud-electronics LE-1 Manual do Utilizador descarregar pdf (Página 2)

LE-1 Installation Guide v1.02

Introduction - continued

Two types of input connector are provided: dual phono sockets for line level signals

with a nominal level of 0dBu), and a 3.5mm stereo jack socket for higher level signals

(approx. +8dB nominal), such as are found at the headphone output sockets of portable

audio devices. Gain trim adjustment (±12dB) is available on the faceplate, and a red

“Peak” LED illuminates when an input signal exceeds nominal level. The gain should

be adjusted so that the LED illuminates briey only on the loudest sections of audio

programme.

Mounting - mechanical

The Cloud LE-1 ts a standard dual-gang electrical back box. The back box used should

have a depth of at least 35mm (1.25”). Note that the LE-1 is made in various faceplate

sizes to suit standard electrical plate sizes in use in the UK, USA and Australia; ensure

you have the correct version for your territory.

Wiring

The LE-1’s OUTPUT connector should be connected to one of the DCM-1’s

EXTENSION PORTs (Line inputs 1 to 4) with screened CAT-5 cable and shielded

RJ45 plugs. Do not connect any other equipment to the phono sockets of the same-

numbered Line Input on the DCM-1.

Connect to

Output socket

Screened

CAT-5 cable

LE-1

OUTPUT

LINK

Microphone Inputs

Extension Ports

DCM-1

Connect to an

unused Extension Port

1 2 3 4

Sem comentários

Cloud-electronics LE-1 Manual do Utilizador Página 2